LIGHTING & POWER SUPPLIES
GENERAL LIGHTING INFORMATION
Hillphoenix cases are equipped with LED luminaires and fea-
ture specially designed light reflectors in the cornice to improve
the illumination of products. LED power supplies operate both
the cornice and shelf lights and are located above the cornice
reflectors.
The lighting system has an ON/OFF switch located in the
race-
way, power box or at the inside back of the case
. Once a case
has been properly positioned in the store and an electrician
has connected the lighting circuit, the lights may be turned on
to verify that they are connected and functioning properly.
To ensure peak performance, it is advisable to run the lighting
systems only when the store climate control is on and case
refrigeration is started.
Note: It is highly recommended that
the ambient store temperature not exceed 80°F.
D A N G E R
▲
SHOCK HAZARD
Always disconnect power to case when cleaning,
servicing or confi guring components of the light-
ing system. Failure to do so may result in serious
injury or death.
W A R N I N G
▲
Using improper DC power supplies may damage
the luminaires, resulting in sub-standard opera-
tion and increased chances of safety issues/
injury.
W A R N I N G
▲
Never replace a 24V DC power supply with a T8
or T5 ballast of
any kind! Ballasts use alternating
current (AC) instead of direct current (DC) and
operate at a much higher voltage than is used by
this LED system. Doing so will damage the LED
system and increases the chance of safety
issues/injury.
REPLACING LED LIGHTS
Once store power is connected and the light circuit is ener-
gized, the Clearvoyant LED system should operate without the
LED LUMINAIRES
Removing LED luminaires:
1.
Unplug the luminaire (Fig. 6).
Fig. 6 LED light power cord
Fig. 7 LED light & ring/clamp
RING & CLAMP
SCREW
2.
Remove the screws from the light clamps (Fig. 7) while
keeping ahold of the light. Once the screws are removed
the light rod will come away from the case with the clamps
still holding to the light.
LED DRIVER/POWER SUPPLY ACCESS
To gain access to the LED driver or power supplies look to the
back of the interior lower storage. The power supply can be lo-
cated here mounted to the interior back panel wall.
need for any signifi cant maintenance for several years. Should
a power supply need to be removed and/or replaced, turn off
the power to the case before proceeding. Be certain to replace
the power supply with genuine Hillphoenix parts or a compa-
rable UL-listed Class-2 rated regulated 24V DC power supply
with 100W output capacity.
3.
Remove the closed clamps and inner rings (Fig. 8) by un-
clipping the clamp ends located above the screw opening.
This will release the grip around the inner ring (Fig. 9) and
allow for the two pieces to be separated from one another.
4.
Carefully remove the inner rings from around the light rod.
10
