Setting a Dimmer Switch
Setting a Dimmer Switch
Step 1 -
Switch Configuration
Step 4 -
Assigning an Output Channel
Step 5 -
Writing Programming to a Switch
Step 2 -
Dimming Type
Step 3 -
Assigning an Address
Using the UP/DOWN buttons, move the cursor until it highlights the ‘Dimmer Switch’ field.
Using the UP/DOWN buttons, move the cursor until it highlights the ‘Type’ field. Select the
dimming type (Dim an individual output channel or Dim a group) to apply to the switch that
you are programming by rotating the scroll wheel clockwise or counterclockwise.
Using the UP/DOWN buttons, move the cursor until it highlights the ‘Addr’ field. Select
the address you wish to assign the switch by rotating the scroll wheel clockwise or
counterclockwise.
*Applicable only when programming an individual dimmer
Using the UP/DOWN buttons, move the cursor until it highlights the ‘Ch’ field. Select the
output channel you wish to assign the switch by rotating the scroll wheel clockwise or
counterclockwise.
Using the UP/DOWN buttons, move the cursor until it highlights the bottom right field.
Rotate the center scroll wheel until ‘Write’ is highlighted. Point the Infrared transmitter
approximately 0.5” away from the IR lens of the switch being programmed and press the
center button of the IR Setting Unit. You will hear a single solid beep sound indicating that
the switch was successfully programmed.
universaldouglas.com
PAGE 6
