AssuredSAN 4004 Series FRU Installation and Replacement Guide
19
Enclosure bezel for 12-drive model
The LFF 12-drive enclosure supports a bezel sub-assembly that attaches to the front of the chassis (see
). The bezel—comprised of a vented cover attached to an EMI (Electromagnetic Interference)
shield—is pre-assembled and packed with foam into a box included in the master shipping container. The
bezel might optionally include a removable air filter that can be serviced or replaced. Hard copy
instructions for attaching/removing the bezel, and for servicing or replacing the air filter, are provided in
the shipping container of a new enclosure.
Alternatively, you can access the document online. See Dot Hill’s customer resource center (CRC) web site
for additional information:
.
NOTE:
The enclosure bezel geometry shown in illustrations within this document may be slightly different
than the bezel shipped with your product, but the ball stud attachment points are the same.
Basic bezel attachment and removal instructions are provided beneath
Figure 10
Partial assembly showing bezel alignment (2U12)
NOTE:
For more information about servicing or replacing the removable air filter option for this particular
bezel, refer to the
AssuredSAN 12-drive Enclosure Bezel Kit Installation
instructions included in your product
ship kit.
IMPORTANT:
For information about compatible drive enclosures supported by 4004 Series 12-drive
controller enclosures using the 2U12 chassis, see
Ball stud on chassis ear
(typical 4 places)
Enclosure bezel sub-assembly
(EMI shield and removable air filter)
Pocket opening (typical 2 places)
