Fig. 18: Disassemble seal
9. Push in assembly plug (6) carefully into
the gun housing behind the trigger lever.
The contact surface of the assembly plug
must point in the direction of the trigger
lever.
10. Push in installation wrench (8) carefully
into the gun housing from the back.
11. Push in dismantled needle (9) through
the installation wrench (8) into the gun
housing.
12. Push trigger through.
ð
The seal on the inside is pushed on
installation wrench (8).
13. Pull out needle (9).
Fig. 19: Disassemble seal
14. Pull out installation wrench (8) with seal
(10).
15. Pull out assembly plug (6).
16. Replace worn out or defective compo-
nents.
Assembling
17. Push seal (10) on the installation
wrench.
18. Push in installation wrench (8) with seal
(10) from behind into the housing.
Press-in seal.
19. Pull out installation wrench (8).
ð
The seal (10) remains in the housing.
Faults
05/2018
EcoGun 116 - MSG00017EN
24/44
