5.4.7 Configuration
Configuration data is imported from an actuator to the programmer.
Existing configuration data of components is overwritten following confirmation on the
programmer.
Activate the electronics on cabinet lock 21 10 by pressing briefly on the door.
1.
Press the Import menu button.
ð
The Import menu opens.
2.
Log the master into the component.
3.
Select the Configuration menu.
4.
Press the ENTER button.
ð
The configuration of the actuator is read and confirmed.
5.5 Manual settings
Use the programmer and the 'Settings'/'Actuators'
menu to configure basic settings
on the actuators.
5.6 Firmware update of components
5.6.1 Firmware update of V4 actuators
The Programmer 1460 is required for the firmware update V4.
Before the firmware of actuators can be updated, the firmware version of the Programmer
should be checked and if necessary, the firmware of the Programmer must be updated.
The firmware update of OSS-SO is carried out like the firmware update of V4.
If there is already a configuration stored in the Programmer for this component, it can be
overwritten by the configuration from the component.
A connection of the component to a wireless gateway must be manually restored after the
firmware update.
Requirements
•
The new firmware is saved on the Programmer.
•
The Programmer's battery is charged. The update procedure can take a few minutes.
•
The programming cable is available.
•
A valid master medium available.
configured components
If the firmware of a component that is configured is to be updated:
1.
Connect the Programmer to the component using the programming cable.
2.
Log in to the component with the master.
3.
On the Programmer, select the ‘Firmware update’ menu.
4.
Select the component and the firmware.
ð
All the firmware versions for the connected component are displayed.
Programming
User Manual
35
- 06/2021
dormakaba Programmer 1460
