12
E. Delete Sensor Location
This step is only used when a sensor is to be removed from the memory of the monitor. This
would be used to remove a sensor from one position and locate it to a different location, or to
remove a sensor. If deleting a sensor is not necessary at this time, please see the second note
below:
NOTE: To enter directly into this program mode you will need
to press the
button for 5 seconds until the
is displayed. Then press the
button
again briefly 4 times to enter this mode (see Figure 2-20 for
screen display).
PROG
ROGRAM
PROG
P
Figure 2-20
NOTE:
To skip this section and go directly to the High Pressure Alarm Programming mode just
press the PROG button briefly 1 time. The display should look like Figure 2-23 or 2-24. Anytime
during this mode you can escape out to the next program mode by pressing the PROG
momentarily. If you want to return to the normal operation mode press and hold the PROG button
for 5 seconds.
The monitor will display the available sensors to delete and the words PROGRAM and DELETE
will be displayed on the screen (
see Figure 2-20
). If a sensor does not need to be deleted you
can just press the PROG button to go into the final program mode. If a sensor will need to be
deleted you will need to do the following steps:
1. Using the arrow keys select the desired sensor that
need to be deleted. The monitor will only display the
wheel positions that have a sensor programmed to
that position. When you select a position the three-
digit number that was programmed will be displayed
so you will be able to verify that this is the correct
serial number to delete (
see
Figure 2-21
).
2. When you have selected the location press and
hold the SET button for three seconds. The three-
digit number will flash twice and the beeper will beep
twice to confirm that this position has been deleted. A
different position will be displayed and the tire
location that was deleted will now be gone (
see
Figure 2-22
).
Figure 2-21
Figure 2-22
II. SETUP AND INSTALLATION
