Doosan 10/105CWJD, Electronic Service Manual

Page: 112 / 139

Book: 23227143 (8-24-2010) Rev C
Page 110
Deutsch HD30 and HDP20 Series Connector Service Procedures
Contact Insertion
1. Grasp contact approximately (25.4
mm) one inch behind the contact crimp
barrel.
2. Hold connector with rear grommet
facing you.
3. Push contact straight into connector
grommet until a positive stop is felt. A
slight tug will confirm that it is properly
locked in place.
NOTE: For unused WJDe cavities,
insert sealing plugs for full
environmental sealing
Contact Removal
1. With rear insert toward you, snap
appropriate size extractor tool over the
WJDe of contact to be removed.
2. Slide tool along into the insert cavity
until it engages contact and resistance
is felt.
3. Pull contact-WJDe assembly out of
connector.
NOTE: Do not twist or insert tool at an
angle