1506-065-K-6-17
9
2.1 Re-Programming the Master Code
2.2 Relay Strike Time
Step 1.
Open the cabinet and locate the
Master Code switch on the circuit board.
Turn switch
ON
.
Step 2.
Enter a four-digit master code using the keypad, then press “
*
” (A short beep will be heard).
Step 3.
Turn
OFF
the Master Code switch and close cabinet.
Write down master code and keep it in a secure place.
?
?
?
?
any four numbers
Then press
“BEEP”
Same keystrokes as written in this manual:
[ _ _ _ _
*
(beep)]
Actual keystrokes used on keypad:
SECTION 2 - PROGRAMMING
Before You Start Programming: IMPORTANT!
Make sure the 1504/1506 has power and we suggest that you become familiar
with programming instructions before beginning any programming.
Keep a record of the programmed codes by completing the tables on pages 24 and 25.
The Master Code has been pre-programmed at the factory to 9999
. This programming sequence re-programs the
MASTER
CODE
if desired. The master code is the four-digit number required to gain access to the system memory. You
MUST
know the
master code before programming
ANY
features.
Important Note:
After re-programming the master code, write it down and keep it in a safe place.
There is no way of retrieving
the master code after it has been programmed in.
If you forget it, you will have to program in a new one but all other previously
programmed information will remain intact.
The relay strike time sets the amount of time that the relay(s) will be activated when a valid entry code is entered on the keypad.
The unit has two relays, both of which can be programmed with individual strike times. Setting the strike time to “
00
” will
activate the relay for ½ second. It can be set to a max of 99 seconds. Two digits
MUST
be entered in the fields.
Factory setting is 01 (1 Second).
1.
Press
*
0 3 and enter the MASTER CODE.
[
*
0 3 _ _ _ _ (beep)]
2.
Enter the two-digit strike time for Relay 1 (00-99), then press
*
.
[ _ _
*
(beep)]
3.
Enter the two-digit strike time for Relay 2 (00-99), then press
*
.
[ _ _
*
(beep)]
4.
Press 0 # TOGETHER to end.
[0 # (beeeeeep)]
2.3 X Strikes for Invalid Entry Code Attempts
This keypad has a
3-minute lockout feature
that is activated when “X” number of
INVALID
entry codes are entered on the
keypad. The “X” strikes can be programmed from
1
to
9
invalid attempts before the lockout feature is activated.
Factory setting is 3 (3 Attempts).
1.
Press
*
0 4 and enter the MASTER CODE.
[
*
0 4 _ _ _ _ (beep)]
2.
Enter the single-digit invalid attempts before the lockout feature is activated (1-9), then press
*
.
[ _
*
(beep)]
3.
Press 0 # TOGETHER to end.
[0 # (beeeeeep)]
ON
OFF
ON
OFF
Note:
After you turn ON the master code switch, the system will sound a short
tone after 30 seconds if the master code is not entered. This tone will continue
every 30 seconds until a new master code is entered, or until the switch is
turned off.
Summary of Contents for 1506-086
Page 2: ......
