SET ACCESS CONFIGURATION
• Card or PIN (Default):
The User must present a valid card/fob to the SK401-E or enter their PIN code
followed by the # key, in order to be granted access
• Card + PIN:
The User must first present a valid card/fob to the SK401-E and then enter their PIN code
followed by the # key, in order to be granted access
Programming Step
Keystroke Combination
1. Enter Program Mode
﹡
(Master Code) #
2.
Card or PIN
Relay 1
Relay 2
3. Card + PIN
Relay 1
Relay 2
(Default)
4 1 0 #
4 2 0 #
4 1 1 #
4 2 1 #
4. Exit Program Mode
*
User Settings
To enter the programming mode
* Master code #
To exit from the programming
mode
*
Note that to undertake the following programming, the Master PIN must be entered
Note:
When adding users, if the card/fob or Pin user has been enrolled already, you cannot add it again on the
same relay, or the device will give a bleep as an error. It is ok to enroll the same card/fob or PIN for both
relay outputs
Factory default setting: Card or PIN
mode
To set users for Relay 1. 4 1 0 #
To add
PIN
users
1 User ID number # PIN #
The ID number is any number from 1-1000
The PIN is any 4-6 digits between 0000-999999 with the exception of
1234 which is reserved. Users can be added continuously without exiting
programming mode as follows:
1 User ID no 1 # PIN # User ID no 2 # PIN #
To delete
PIN
users
3 User ID number #
Users can be deleted continuously without exiting programming mode
To change the
PIN
of a PIN user
(Note: This step must be done out of
programming mode)
* ID number # Old PIN # New PIN # Repeat new PIN #
