7
Donaldson Company, Inc.
7. Check for any accumulation of dust remove as necessary.
8.
Install a new filter onto yoke with gasket oriented towards the collector.
9. Reinstall the access cover onto yoke. The smooth corner of the cover should be oriented towards the top as shown in the
triagonal access cover.
10.
Engage knob and turn clockwise to seal the gasket on the filter to the tubesheet. Tighten knob by hand or tool.
The access cover must be properly aligned to ensure a dust tight seal to the housing.
Do not exceed 150-in- lbs (12.5 ft-lbs) torque when securing the access cover as over tightening may
cause damage to the filter and/or equipment.
When filter replacement is complete, check to ensure that each access cover is seated and sealed against the filter
housing to ensure a dust tight housing seal.
Light Bulb Replacement
This light fixture is serviced from inside the booth. Replace per the light manufacturers specifications.
Optional Afterfilter Replacement
1. Loosen the retaining screws and clamping straps and pull the afterfilters out of the frames.
2. Install the new afterfilters with the seal edge towards the power module cabinet. Airflow is from the inside of the plenum to the
outside.
3. Position the clamping straps and tighten the wing screws to secure the new afterfilter.
