FUSION HE
2
1
SAFETY WARNINGS
1.1
Usage and installation warnings
The
FUSION
module should be installed by personnel authorised by the Ministry of Industry, in
compliance with the laws and regulations in force in the matter. The precautions detailed here
cover very important issues, so please be sure to follow them accordingly.
Please carefully read this instruction manual and keep it in a safe, easily-accessible place.
DOMUSA
TEKNIK
shall not be held liable for any damage that may occur due to failure to follow these
instructions.
The
FUSION
storage module can only be installed in combination with a heat pump from the
DUAL
CLIMA
line from
DOMUSA TEKNIK
. The
FUSION
module, in combination with a
DUAL CLIMA
heat
pump, is suitable for use in both heating and cooling installations, and can be combined with fan
coils, underfloor heating/cooling and low-temperature radiators. It should be connected to a
heating/cooling system and to a hot water distribution network that is compatible with its
performance and power.
This appliance should only be used for the purpose for which it has been expressly designed. Any
other use is considered unsuitable and therefore hazardous. The manufacturer shall not be
considered liable under any circumstances for damage caused by unsuitable, erroneous or
improper use.
Remove all the packaging and check that the contents are complete. In case of doubt, do not use
the appliance and refer to the supplier. Keep the packaging elements out of reach of children, as
they can be dangerous.
Improper installation or placement of equipment or accessories may cause electrocution, short
circuit, leakage, fire, or other damage to the equipment. Use only accessories or optional
equipment manufactured by
DOMUSA TEKNIK
and specifically designed to work with the products
presented in this manual. Do not modify, replace or disconnect any safety or control device without
first consulting the manufacturer or the Official Technical Assistance Service of
DOMUSA TEKNIK
.
When it is decided not to use the equipment anymore, the parts likely to constitute potential
sources of danger should be properly decommissioned.
1.2
Personal safety warnings
Always wear suitable personal protection equipment (protective gloves, safety glasses, etc.) when
carrying out installation and/or maintenance operations in the unit.
Do not touch any switch with wet fingers. Touching a switch with wet fingers may cause electric
shock. Before accessing the electrical components, fully disconnect the power supply.
Do not touch water pipes or internal parts during and immediately after operation. Pipes and
internal parts may be excessively hot or cold, depending on the use of the unit.
The hands may be burned by cold or heat in case of improperly touching pipes or internal parts. To
avoid injury, wait until the pipes and internal parts return to their normal temperature.
Alternatively, if access is required, be sure to wear appropriate safety gloves.