4.2.5. Other functions
•
Reset to factory parameters:
The factory parameters can be reset with the following sequence:
o
The electrical power supply should be disconnected from the machine.
o
With the machine stopped, press the Start button. While the Start button is pressed,
reconnect the electricity. Next release the Start button.
o
All the dryer parameters will be restored to the factory parameters and according to whether
it is configured in OPL mode or in self-service mode.
•
Reset balance to 0:
In self-service mode, if necessary the balance can be set to 0 using the
following combination of keys:
o
The electrical power supply should be disconnected from the machine.
o
The electricity should be reconnected.
o
Within the first 2 minutes after powering the dryer, if the low and high temperature keys are
pressed together for 10 seconds, the accumulated balance will reset to 0. If these keys are
pressed together after the 2 minutes, it will not have any effect.
•
Parameter edition:
it is possible to modify certain operating parameters of the control using the
ELECTRONIC CONTROL console
(sold separately).
4.3.
How to run a drying cycle
•
OPL Mode:
When the machine is in WAIT mode, proceed as follows:
1. Select the required drying time using the time increase/decrease keys. The default time selected
is 40 minutes.
2. Select the required drying temperature using one of the 3 temperature keys. The default
temperature selected is Medium.
3. Press START/STOP keypad to start the drying cycle.
•
SELF-SERVICE Mode:
When the machine is in WAIT mode, proceed as follows:
1. Enter the required time with the stipulated payment (coin slot, payment centre, etc.).
2. Select the required drying temperature using one of the 3 temperature keys. The default
temperature selected is Medium.
3. Press START/STOP keypad to start the drying cycle.
27
