To check the ignition sequence the following steps should be followed: 1.- Load the appliance with the
fabric to dry. 2.- Choose a high temperature set point, for example maximum temperature. 3.- Start the
drying cycle. Once the drying cycle has started, the fan and drum motor will start immediately, and the
gas heater will try to ignite after 30 seconds. If after an additional 30 seconds (60 seconds in total), the
ignition has not occurred correctly, the appliance will display an alarm.
Clothes dryer input ratings are based on sea level operation and need not be changed for operation up
to 2000 ft (610 m), input ratings should be reduced at the rate of 4 percent for each 1000 ft (305 m)
above sea level.
Each different gas and inlet pressure requires correct adjustment of the burner pressure and use of the
correct injector as outlined in (injector replacement) for proper combustion.
Once the adjustment has been carried out correctly, the flame should have the following appearance (as
indicated in the photo below). To visualize the flame there is a peephole in each machine. (See below de
photo).
22
