Dometic TEC60, Installation Manual

Page: 34 / 220

EN
Connecting the electrical power to the generator TEC60
34
10 Connecting the electrical power to the
generator
D
I
10.1 Important notes on the electrical connection
 Only a qualified electrician should connect the generator to the electrical
power.
 Check that the voltage specification on the type plate is the same as that
of the power supply.
 Do not lay the 230 V
w
mains cable and the 12/24 V
g
cable together in
the same cable duct.
 Do not lay cables which are loose or bent next to electrically conductive
material (metal).

Connect the generator to a power circuit which can supply the necessary
current (see chapter “Technical data” on page 38).

Select the cross-section of the cable as follows:
– 230 V: 6 mm²
– Battery connection (length < 6 m): 16 mm²
– Battery connection (length > 6 m): 25 mm²
 Install a manual main switch which can disconnect all the consumers from
the generator with the exception of the battery.
DANGER! Danger of electrocution
Make sure there is no voltage at electrically operated components
before carrying out work on them!
NOTE
Observe the applicable guidelines in the country of the consumer.