EN
SMP301-07
Scope of delivery
9
•
Only charge rechargeable batteries.
•
Only charge the battery if it is not frozen.
•
Do not put the battery charger on the battery.
•
Do not cover the battery charger.
•
Only use the battery charger if the casing, connections and cable are
undamaged.
A
NOTICE!
•
A charging voltage of up to 15 V is possible during the charging pro-
cess. Ensure that there are no consumer units connected to the battery
during the charging process. This is to prevent the consumer units
connected from being damaged.
•
The battery charger switches to preservation mode following the
charging process. If the battery charger does not switch out of charge
mode, disconnect the battery charger from the battery. Have the bat-
tery charger checked by a specialist electrician.
•
Regularly check the battery for damage and for errors when it is in use.
A defective battery is detected by the battery charger during the
charging process.
3
Scope of delivery
•
Power supply unit
•
Battery charger
•
Installation and operating manual
4
Intended use
The power supply unit SMP301-07 (ref. no. 9106505556) is suitable for installation
in habitable recreational vehicles (e.g. motor homes, caravans, boats etc.). The
power supply unit SMP301-07 is used as the voltage supply for the DC consumer
units and can be supplied with AC or DC.
The battery charger is suitable for charging 6-cell lead batteries (lead-acid, gel,
AGM) with a capacity of 50 Ah to 300 Ah. Do not use the battery charger for any
other purpose and do not use it to charge other types of batteries.
The power supply unit and battery charger are approved for permanent operation.
SMP301-07-IO-7s.book Seite 9 Montag, 16. Januar 2017 1:08 13
