Dometic DC-Kit5, Operating Manual

Page: 15 / 292

EN
DC-Kit5 Installing and connecting the DC kit
15
Observe the following safety instructions for the electrical connections:
A
Observe the following instructions when selecting the location for installing the
components:
•
Make sure the cables are of the correct length.
•
Choose a well-ventilated installation location near the supply battery.
7.1 Preparing the installation
➤
Disconnect the following voltage supplies in the vehicle:
–
Positive battery terminal
– External voltage supply
7.2 Installing components
➤
Install the ECL-103 charging current distributor.
➤
Install the MSI1824T inverter.
➤
Install the MCR-9 remote control.
D
NOTICE! Risk of short circuit!
•
First, disconnect the 230 V external power supply to the caravan.
•
Disconnect the earth connection to the supply battery.
•
Disconnect the connection to the starter battery.
•
If you have to feed cables through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
•
Do not lay cables which are loose or bent next to electrically
conductive material (metal).
•
Fasten the cables securely.
•
Ensure the 24 V cables are especially well-protected.
•
Check whether you need to fit any additional fuses.
•
Do not pull on the cables.
•
Do not lay the 230 V mains cable and the 12/24 V DC cable in the
same duct.
•
Lay the cables so that they cannot be tripped over or damaged.
DANGER! Electrocution!
Only connect the battery once you have the completed all the
installation work and you are certain it has been done properly.
DC-Kit5--IO-16s.book Seite 15 Dienstag, 21. März 2017 2:32 14