Page 8
Mouser Advanced User Manual
Factory Reset & Misc. Functions
Resetting the Mouser
If needed, the Mouser can be reset locally by following these steps. Only do this
when your Z-Wave controller is disconnected or otherwise unreachable. Beware
that resetting your device will disconnect it from the system:
1. Remove the TOP COVER and confirm that your Mouser is powered up.
2. Press and hold the CONNECT BUTTON for at least 10 seconds then re-
lease. A flashing LED INDICATOR indicates a successful factory reset.
3. The Mouser’s memory will be erased to factory settings.
Waking Up The Mouser
Because the Mouser is a battery powered device, it wakes up on regular inter-
vals to give battery and other status updates to the controller, as well as to ac-
cept configuration settings from the controller. This helps to extend the battery
life. The device can be forced to wake up to submit these reports or accept new
settings immediately by simply pressing and holding the BUTTON for two sec-
onds. The LED INDICATOR will flash once indicating successful wake up.
Factory Reset & Misc. Functions
