Page 9
Door/Window Sensor Advanced User Manual
Physical Installation
The Door/Window Sensor can be secured with the pre-applied double stick
tape or the provided hardware. The device should already be included in
your Z-Wave system before continuing further.
Pre-Installation Checklist
9
The Magnet Assembly and Sensor Assembly should be less than
1-1/4” apart when closed (Figure 3.)
9
Hold the Magnet Assembly and Sensor Assembly in place by hand
where you wish to install them, move them in and out of the closed
position, and make sure the LED Indicator blinks in response. This will
confirm that the door and frame are spaced correctly to accommodate
the sensor.
9
When moving the Magnet and Sensor in and out of the closed position,
a Green followed by another Green or Red LED Indicator corresponds
to Excellent or Poor Z-Wave Signal strength respectively.
9
Make sure the Sensor Cover Release Button will be accessible in the
final position.
9
The Magnet is small enough (only 1/4” wide) to fit in the groove between
the door and the casing.
9
Finally, confirm that you are still within range of your Z-Wave controller.
Max 1-1/4”
Figure 3 - Placing the Door/Window Sensor on the Door
Physical Installation
