Page 7
Door/Window Sensor Advanced User Manual
Inclusion & Exclusion
Inclusion (Add to System)—New Installation
1. For proper inclusion, bring the Door/Window Sensor to the final location where
it will be used*.
2. Follow the instructions for your Z-Wave controller to enter inclusion mode.
3. Remove the Battery Tab protruding from the Battery Tab Slit.
4. The device will automatically enter inclusion mode for two minutes and the
LED Indicator will alternate between green and red.
Upon successful inclusion the LED Indicator will flash green three times then stop
blinking.
Inclusion (Add to System) —Re-Installation
1. For proper inclusion, bring the Door/Window Sensorto the final location where
it will be used*.
2. Follow the instructions for your Z-Wave controller to enter inclusion mode.
3. Remove the Sensor Cover and the LED Indicator will start blinking yellow.
4. Press the Button quickly 3 times in a row.
5. The device will enter inclusion mode for two minutes and the LED Indicator will
alternate between green and red.
After successful inclusion, the LED Indicator will flash green three times then
blink red until the cover is replaced.
Exclusion (Remove from System)
Follow the instructions for your Z-Wave Certified Controller to enter exclusion
mode. When prompted by the controller:
1. Remove the SENSOR COVER and the LED Indicator will start blinking red.
2. Press the Button quickly 3 times in a row.
The LED Indicator will flash green three times indicating exclusion/disconnection
and will then continue flashing red (indicating tamper) until the cover is replaced.
*For non Z-Wave Plus networks, please consult the owner’s manual for your primary controller to determine the best method and location
for adding the Door/Window Sensor to your Z-Wave network.
Inclusion & Exclusion
