Dolphin WAVE 100, Operating Instructions Manual

Page: 9 / 32

�
ril
113"F45"C
�
41"F 5
°
Fig
8) Helpful tips
• Optional coarse filter bag far collecting large debris is included.
• Clean filter bag whenever you remove the DOLPHIN WAVE 1 DO from the pool.
A dirty bag can become dry and unusable.
• Ensure PH level of pool water [optimally 7.0 - 7.4].
• Ensure Chiarine level of pool water [optimally 2 to 4 ppm].
• Ensure an ideai water temperature 54
°
F- 90
°
F (12
°
C - 32
°
C).
• Ensure that the brushes [15 page-9] are in good condition.
• Always switch the power supply "off", wait 30 seconds and switch "on" aga in to start a new cleaning cycle.
• Stare the DOLPHIN WAVE 1 DO upright on the Caddy- not on its brushes - in the shade and at a temperature
of between 41
°
F - 113
°
F (5
°
C - 45
°
C). Coi I the cab le loosely a round the Caddy hooks [Fig L].
• Wonder brushes or combined brushes should be thoroughly washed and squeezed.
• To prolong Wonder brushes or combined brushes longevity, it is recommended that they be kept wet at all
times even when stored far a long period of time.
• Far troubleshooting go to www.maytronicsus.com
9) Gene rai specifications
Calculated Ground Speed
Calculated Scanning Rate
Suction Rate [self contrai led]
Weight [w/o cable]
Power Supply
Input Voltage
Output Voltage
Rated output
50 ft/min
63 ft 2/min
79 gal/min (USA)
23.5 lb
100 VAC / 115 VAC / 230 VAC
30 VDC - nominai
115 VAC - 150 W / 230 VAC - 150 W
These specifications may vary far different swimming pools and far the various electrical configurations.
Although the DOLPHIN WAVE 1 DO has been tested in a wide range of swimming pools, MAYTRONICS cannot
accept responsibility if the DOLPHIN WAVE 1 DO is not entirely suitable far any particular swimming pool.
Note:The
sealed motor unit and the DOLPHIN WAVE 1 DO power supply conta in no user-serviceable parts.
Opening these units will automatically invalidate your warranty.
The manufacturer reserves the right to change these specifications without prior notice.
U.S. Patent No. 4168557. S.A. Patent No. 76/7474. AUST Patent No. 509698.
7