MXP924
User’s Guide –
Dolphin Interconnect Solutions
Page 10
Operation
Configuration and DIP Switches
The MXP924 has two banks of 8 DIP switches. The default factory setting for the MXP924 is Transparent Target mode, single (up to
x16) link connection.
The MXP924 has DIP switches for setting special modes or operations, the meaning of each DIP switch depends on the loaded
firmware. Please carefully read the documentation shipped with the module before modifying any DIP switch settings. Please pay
close attention to ON and OFF positions written on the DIP switch.
DIP Switches
Figure 1: DIP Switch shows the DIP switch for the MXP924. It is used to configure the PXIe
module. Please leave all undocumented DIP switches in the default position. Table 3: DIP
SW1 settings and Table 4: DIP-SW2 settings below shows all the various DIP switch settings
for the MXP924.
Note: DIP switch configuration options may be changed in the future versions.
Please always consult the latest user guide for details. The table above is valid for
version 1.5.
DIP-Switch SW1 settings
SW1 DIP
no.
Description
ON
OFF
Default
1-8
Configuration selector, details
below
OFF
Table 3: DIP SW1 settings
DIP-Switch SW2 settings
SW2 DIP
no.
Description
ON
OFF
Default
1
Reserved, leave in Default OFF
OFF
2
Enable Wake
Enable PCIe WAKE
PCIe Wake Disabled
OFF
3
Reserved, leave in Default OFF
OFF
4
Disable thermal shutdown
Thermal shutdown
disabled
Shut down the switch if
critical temperature
reached.
OFF
5-8
Reserved, leave in Default OFF
OFF
Table 4: DIP-SW2 settings
Figure 1: DIP Switch
