THE JUMPER FOR BACKLIT OPTIONS
Located on the upper-left corner; the two options are for full lights or
auto lights.
1. Full backlit – The keypad constantly illuminates.
2. Auto backlit – The keypad only illuminates during use.
DIRECT ACCESS PROGRAMMING WITH CODE: 8080
If you have forgotten the master code there is still a way to enter
programming mode. In order to do this you need to either have an
egress button installed, or you need to simulate an egress button.
1. First you drop the power to the keypad for one minute.
2. You then power the keypad back up and
DURING the one minute
of beeping
either push and hold down the egress button that has
been installed or bridge a wire from the egress in
(terminal 9)
to the
negative ground power
(terminal 15).
3. While you are either pushing the button or with the two terminals
bridged, press
4. Immediately after pressing the second *the beeping should cease
and the amber light should hold steady. At this point you are in
programming mode. Immediately upon entering programming mode
you need to create a new master code. This is accomplished by
pressing
RESET TO FACTORY SETTINGS WITH CODE: 9999
While in programming mode, enter:
·
Allow up to 2.5 minutes for the keypad to reset. The yellow LED
will indicate when the keypad has finished resetting
·
Note: The current Master Code will not reset
9
0
9
1
9
9
* *
New Master Code
(4-8 digits)
#
#
8 0
0
8
