Dolby
®
Model CP650 Installation Manual
Accessories
8-5
8.2.6
Connect to the CP650
1. Connect the interface wires to the six-way connector shown in the figure below. If
you cannot locate the connector, you can order one (Part No. 70206) from Dolby
Laboratories.
Note:
All remote units attach to the same terminals on the connector. Do not connect
wires from any Dolby remote unit to terminal 4, 5, or 6.
2. Plug the connector into the
Remotes and Aud Fader
input on the CP650
rear panel.
7.0
1
3
2
5
4
6
DATA
V
GND
REMOTES AND AUD. FADER
FADER
REMOTE
+
DATA
IN
N/C
CP650 rear panel
7.0
DATA
V
GND
Remote Control
Cat. No. 779
Cat. No. 779
back
Six-way
Bare-wire
Connector
Remote Fader
Cat. No. 771
Cat. No. 771
back
GND
DATA
V
GND
DA
TA
V
Customer-supplied
Auditorium Fader
(100K linear pot)
Figure 8–5
Connection of Remotes to the CP650
You can confirm that remote units are connected and communicating with the CP650
by selecting the Remote Addresses menu on the CP650.
+
Press the left menu button multiple times, or press
and hold
the button while rotating the front-panel
knob to move the display to the
Remote
Addresses
menu.
The single-digit address of each connected remote
unit is displayed.
