CANICOM 200 – User’s guide – May 2009
7/12
Press the «C» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar, the duration will be as long as you press the button but limited to 8
seconds maximum.
Note: Beeps can be associated to the stimulations by first pressing the “C” button and then the button.
« + » and « - » : control buttons
Use the “+”/”-“ buttons for rapid adjustment of the stimulation levels of the receiver collar.
9 levels are available.
Level 1:
very weak stimulation – Level 9: strong stimulation
●
Checking/replacing battery in remote control
The performance (radio range) of the remote control may deteriorate as batteries become
weak. Be prepared to replace the battery.
To check the condition of the battery, turn on the remote control and look at the battery level indicator on
the LCD screen. The symbols which appear indicate the following:
Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your CANICOM 200 functions in safety mode and the system locks up. The
battery must be replaced.
DOGTEK recommends using the same type and same brand of batteries as those supplied in your new
purchased device. Other brand of batteries might not operate, or not be compatible or alter the
performances of your collar.
The right batteries can be purchased from DOGTEK or from your distributor.
Remove the old battery and replace it with a new one as follows:
▪
On the back of the remote control, unscrew the screw and remove the battery cover.
▪
Remove the old battery.
▪
Insert the new battery (3-V lithium CR 2430) making sure the polarity “+” noted on the
battery is visible (ref. Diagram 6).
▪
Put the lid back in place.
▪
Put the top back, using the screw.
▪
Check the remote control operates correctly.
●
Checking/Replacing battery in receiver collar
To check the condition of the receiver collar battery, observe the indicator light located on the front of the
receiver collar:
9
Battery fully charged: flashes slow green.
9
Weak battery: flashes quickly red. Replace the old battery with a new one (3-V Lithium CR2) (See
§ First use from new – Fitting the battery in the receiver collar).
Check the receiver collar operates correctly.
DOGTEK recommends using the same type and same brand of batteries as those supplied in your new
purchased device. Other brand of batteries might not operate, or not be compatible or alter the
performances of your collar.
The right batteries can be purchased from DOGTEK or from our distributor.
« + » of the
battery must
be visible
Diagram 6
