CANICOM 200 – User’s guide – May 2009
4/12
●
Contents of package
Inside the packaging you will find:
▪
1 receiver collar CANICOM fitted with short contact points
▪
1 lithium 3 Volts CR2 battery for the collar
▪
1 remote control CANICOM 200 fitted with 1 lithium 3 Volts CR2430 battery
▪
1 neon test lamp
▪
1 pair of long contact points
▪
1 carry strap
▪
1 DVD
▪
This user’s guide
●
Description of the product
●
First time using product
Fitting the battery in the receiver collar
▪
Remove the 4 screws of the top of CANICOM using a screwdriver.
▪
Insert the battery (3V Lithium CR2) paying attention to follow polarity indicated on the
battery housing (ref. Diagram4).
▪
A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after having inserted the battery, remove it immediately from its
housing. Check the polarity before trying again.
▪
Before putting the lid back in place, check that the rubber seal is in its groove.
▪
Replace the 4 screws with care (do not overtighten them).
On/Off
switch
Continuous stimulations
limited to 8 seconds
Flash stimulations
lower than 1 second
Adjustment of the level
of the stimulations
Red mark:
Area where
the On/Off
switch magnet
is located
LCD screen
2 contact points
(short or long)
Radio Signal Indicator
Stimulation level
indicator from 1 to
9
Battery level indicator
REMOTE CONTROL
Diagram 1
RECEIVER COLLAR
Diagram 2
LCD SCREEN
Diagram 3
On/Off indicator
+
radio signal
indicator
+
battery level
indicator
