CANICOM 200 – User’s guide – May 2009
6/12
Each remote control has its individual radio operator code. The coding of the remote control with the
receiver collar enables you to sync your remote control with the receiver collar provided.
IMPORTANT: before beginning the coding (first use of the receiver or re-coding), make sure no
other person is using his CANICOM 200 or other products from the DOGTEK range close by:
your receiver collar could accidentally record the code of his remote control. If that occurs, re-
code the remote control with the receiver collar.
CODING PROCEDURE FOR THE 1
ST
USE
1.
Activate the remote control: press the On/Off red button ( ) located on the side of the remote
control for 1 second.
2.
Activate the receiver collar: Place the red mark located on the remote control in contact with the
red mark located on the receiver for 1 second.
3.
Move the remote control away from the receiver collar.
4.
Press the button of the remote control. An audible beep is emitted, the receiver collar is then
synchronized with your remote control.
RE-CODING PROCEDURE (for all codings except the 1
st
one)
1.
Activate the remote control: press the On/Off red button ( ) located on the side of the remote
control for 1 second.
2.
Receiver collar in position « deactivate » (indicator light off): Place the red mark located on
the remote control in contact with the red mark located on the receiver for 6 seconds.
The
indicator on the collar lights in fixed green, then flashes in red.
3.
Move the remote control away from the receiver collar.
4.
Press the button of the remote control. A beep sound is emitted, the receiver is then
synchronized with your remote control.
Reprogram a receiver collar
The receiver collar can be re-coded indefinitely,
either with the same remote control, or with a new
remote control from the CANICOM range. Ref. § Re-coding procedure.
●
How to use the remote control
The CANICOM 200 remote control is designed to operate with 1 receiver collar. For optimal range
performance, hold the remote control in front of you with your arm extended, at least 10 inches away
from your body. Do not cover the top of the remote control unit or antenna with any part of your hand
while holding.
button: beeper
If you press the « Beeper » button the receiver collar will emit audible signals. There is no time limit for
this function: the beeper will continue to sound as long as you press the button.
A « transmission » symbol will appear on the LCD screen of the remote control; the indicator light goes
from flashing green to solid green as long as you press the button.
It is up to you to use the beeper depending on the way you want to train your dog. With the beeper you
can:
- send a sound to your dog when it is disobedient,
- draw its attention, ...
It’s very important to always use the beeper in the same way in order not to confuse your dog.
F button: Flash stimulation
Press the «F» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar for a defined length of time of less than one second.
A « transmission » symbol will appear on the LCD screen of the remote control; the indicator light goes
from flashing green to solid red as long as you press the button.
C button: Continuous stimulation
