DOGA SCOUT II, Instruction Manual

Page: 15 / 40

Instructions manual / Electric screwdrivers
15
P # Name Specification Default
P31 Fastening buzzer
Select one of followings
0 : Not use
1 : OK only
2 : NG only
3 : OK + NG
0
P32 Cycle buzzer
Select one of followings
0 : Not use
1 : OK only
2 : NG only
3 : OK + NG
0
P33 Reset key control
Select Reset key Enable / Disable
0 : Disable 1 : Enable
0
P34 Program key control
Select Program key Enable / Disable
0 : Disable 1 : Enable
0
P35
Program Select Input
with Binary code
Program Select Input by Binary code with
Pin no. 1 ~ 3
0 : Disable 1 : Enable
0
P36
Monitoring data
output setting
Select Enable / Disable of monitoring data
output through RS-232C port
0 : Disable 1 : Enable
0
P37
Cycle start signal
interval required
The interval time between Cycle complete
and new cycle start can be set between
1 ~ 10mS ( unit : 10 mS )
100
P38-P45 Mid count signal for P1~8
Count complete signal comes out after the
set number of Mid-Count during the cycle
0 : No use
1 – 99 : Count number
0
P46 Password
Key in the password in 4 numbers.
Initial factory setting password is ‘’0000’’
If the password is forgotten, click the
Menu on Scout manager control bar with
password ‘’77’’, then all parameters are
changed to the factory settings.
Once again, the factory setting password is
‘’0000’’.
P47 Initial parameters
All parameters are initialized to the factory
settings. Key in ‘’77’’ on P47 and press Enter
button