DOGA SCOUT II, Instruction Manual, Page: 30 / 40

Instructions manual / Electric screwdrivers
30
10. Cycle Start / Stop in the various operating conditions
10.1 Auto Start
- Where fastening number count is not necessary
It starts to count the number of fastening automatically just after cycle ends with "0" display of counter, and repeats without
any cycle start and stop signal for counting. "Auto Start" can be used for monitoring fastening OK / NG condition without
counting of fastening numbers.
10.2 Start ( Continuous ON )
Scout starts counting the fastening number from the ON signal edge and keeps counting until signal OFF. If the number
reaches the target before signal OFF, it makes the Cycle complete OK and provides Cycle end output signal.
Also it verifies the Cycle complete NG, If the ON status turned OFF which means that the fastening work is finished,
because the work piece left the working area.
The display is reset to the target number when the Cycle Start signal is turned ON again.