DOGA DPTC Series, Instruction Manual

Page: 9 / 28

Instructions manual / DPTC Series 9
6 FUNCTIONAL DESCRIPTION FOR WRENCH
This industrial shut off wrench is designed for nut tightening/loosening and screw
driving/loosening. It is not appropriate to use for wood/mild steel drilling. Please refer to the
figure on the page to familiarize yourself with the major components of this tool before use.
1/ Power Switch
Depressing the power switch will energize the LED light (2) in front and the tool starts to rotate.
When released, power to the motor will cease and the tool stops to work immediately. But the
LED light will remain for 5 seconds then off.
3/ Forward/Reverse Button
The tool is always in forward operation unless the Forward/Reverse button is pressed. When
the button is pressed, the yellow and green LED flash together, the tool will be in reverse
operation. To get the tool back in forward operation, just simply press the button again and the
LED would disappear and the tool is back in forward operation.
4/ Anvil (Drive Shaft)
The anvil will accept drive hex socket. Be sure the socket is fully inserted before operating
tool. Otherwise, the socket may fly off and cause property damage or personal injury.
WARNING : Just only use the sleeve sockets.
5/ Li-ion Battery
This battery provides electrical power to the motor. Please charge it according to the charging
instruction listed in this manual.
WARNING : Use the tool to either tighten or loosen nuts and screws ONLY in stipulated
torque and voltage ranges.
4
3
2
1
5
Information to know :
1) No lights on the tools indicates the tool
is in SLEEP mode. To wake up the tool,
just to press the trigger. The tools will
be ready to use.
2)After operating the tool, the impulse
setting number will be remained on the
display for 5 mins. As the number
disappears, the tool goes into SLEEP
mode.