DOGA DPTC Series, Instruction Manual

Page: 8 / 28

Instructions manual / DPTC Series 8
5 FUNCTIONAL DESCRIPTION FOR SCREWDRIVER
This industrial shut off screwdriver is designed for nut tightening/loosening and screw
driving/loosening. It is not appropriate to use for wood/mild steel drilling. Please refer to the figure
on the page to familiarize yourself with the major components of this tool before use.
1/ Power Switch
Depressing the power switch will energize the LED light (2) in front and the tool starts to rotate.
When released, power to the motor will cease and the tool stops to work immediately. But the
LED light will remain for 5 seconds then off.
3/ Forward/Reverse Button
The tool is always in forward operation unless the Forward/Reverse button is pressed. When
the button is pressed, the yellow and green LED flash together, the tool will be in reverse
operation. To get the tool back in forward operation, just simply press the button again and the
LED would disappear and the tool is back in forward operation.
4/ Quick Change Holder
This driver accepts only 1/4” (6.35mm) hexagonal bits. Be sure the bit is fully engaged by the
chuck before operating tool. Otherwise, the bit may fly off and cause property damage or
personal injury.
5/ Li-ion Battery
This battery provides electrical power to the motor. Please charge it according to the charging
instruction listed in this manual.
WARNING : Use the tool to either tighten or loosen nuts and screws ONLY in stipulated
torque and voltage ranges.
4
3
2
1
5