Dodge Challenger 2015, Operating Information Manual

Page: 76 / 689

•
Press the heated seat button a second
time to turn the Low setting ON.
•
Press the heated seat button a third time
to turn the heating elements OFF.
If the HI-level setting is selected, the system will
automatically switch to LO-level after approxi-
mately 60 minutes of continuous operation. At
that time, the display will change from HI to LO,
indicating the change. The LO-level setting will
turn OFF automatically after approximately 45
minutes.
NOTE:
The engine must be running for the heated
seats to operate.
This feature can be programmed through the
Uconnect® system. Refer to “Uconnect® Set-
tings” in “Understanding Your Instrument Panel”
for further information.
WARNING!
•
Persons who are unable to feel pain to the
skin because of advanced age, chronic
illness, diabetes, spinal cord injury, medi-
cation, exhaustion or other physical condi-
tion must exercise care when using the
seat heater. It may cause burns even at
low temperatures, especially if used for
long periods of time.
•
Do not place anything on the seat or
seatback that insulates against heat, such
as a blanket or cushion. This may cause
the seat heater to overheat. Sitting in a
seat that has been overheated could
cause serious burns due to the increased
surface temperature of the seat.
Front Ventilated Seats — If
Equipped
Located in the seat cushion and seat back are
small fans that draw the air from the passenger
compartment and move air through fine perfo-
rations in the seat cover to help keep the driver
and front passenger cooler in higher ambient
temperatures. The fans operate at two speeds,
HIGH and LOW.
The front ventilated seats control buttons are
located within the Uconnect® system. You can
gain access to the control buttons through the
climate screen or the controls screen.
•
Press the ventilated seat button once to
choose HIGH.
•
Press the ventilated seat button a second
time to choose LOW.
•
Press the ventilated seat button a third
time to turn the ventilated seat OFF.
NOTE:
The engine must be running for the venti-
lated seats to operate.
Manual Forward Or Rearward
Adjustment
The adjusting bar is located at the front of the
seat, near the floor. Pull the bar upward to move
the seat forward or rearward. Release the bar
once the seat is in the desired position. Using
body pressure, move forward and rearward on
73