15
ATTENTION
Do not connect the machine to the mains until the electric supply has been thoroughly tested to comply with current regulations.
Verify that the electric network is compliant with the safety and power requirements of DLGs 46/90 and that :
-
The earthing is present and working properly.
-
A safety device is present and working properly.
-
We recommend the presence of an RCD (Residual Current Device).
Connect the supply cable to the mains. Start the machine by pressing the thermo-magnetic switch.
The starting system is protected against accidental starts due to tension coming back after an electric black-out. In such cases, it is
necessary to start the motor again by pressing the green switch.
Single-phase machines: press green switch and contemporarily the white button for 4 seconds.
Three-phase machines: by pressing the green switch , the motor starts and the machine is ready to work.
By pressing red switch, motor is stopped and the blade will stop rotating within 10 seconds.
You can bring the machine to an immediate halt by pressing the emergency- stop switch labeled stop.
By pressing the
green
switch, the motor starts and the machine is ready to work.
By pressing the
red
switch, the motor is stopped and the blade will stop rotating within 10 seconds.
You can bring the machine to an immediate halt by pressing the emergency-stop switch labeled
STOP
.
DANGER
Check periodically that the automatic braking devices are in full working order.
6.3.2 STARTING TO OPERATE THE MODEL WORKING WITH PTO
In case of PTO saw bench, connect 3 points to the tractor lifter, by ensuring dedicated pivots and their blocking linchpin are inserted.
Ensure the cardan shaft is fully inserted, connecting it to the power take-off of the actuator and the one on the machine. Increase the
speed of the actuator and the PTO slowly, for example using the tractor clutch, not to damage any transmission.
Once the job is completed, always disconnect the cardan from the PTO of the actuator.
3
DANGER
Before starting, always ensure the machine is linked to tractor three points, by the
dedicated pivots. Ensure these pivots are blocked by their blocking linchpin.
Verify that the direction of rotation of the cardan shaft is the same as indicated inside
the protection cover.
Always ensure that the blades are free from any sort of hindrance before starting the
actuator.
Do not exceed the maximum rotation speed of the blade, as stated by the manufacturer.
