Changing Retransfer Conditions
(Cont’d)
Setting Procedures
The vertical axis shown in the setting area indicates the retransfer temperature, and the horizontal axis
represents the retransfer speed. Click on the corresponding square to change the value. The selected
value is indicated using “
*
”.
Setting a value toward the top right end increases the transfer force, however heat deformation of the
card will also be greater. The colors below serve as a rough indicator for selection.
Color Description
Green
Standard value. Optimal value for the selected card. Select this under
normal circumstances.
Caution
Light Blue
Appropriate range. Recommended range when selecting a value other
than the standard value.
Yellow
Card bends increases.
Blue
Retransfer defect may occur.
Red
Do not choose these values.
1) The setting areas serve only as a rough indicator. The optimal value varies according to the
card type as well as the environment in which the printer is used. As such, set the values
after trying out under the environment where it is to be used.
2) It may take a while for printing to start when the retransfer temperature is changed.
3) There is only one standard retransfer temperature. Altering the retransfer temperature on
one side changes the temperature on the other side as well.
4) The range of optimal values varies according to the “Card Type”. You can change the card
type in the “Media Setting” screen.
5) If the card type varies across printers, set the card type to use accordingly. The color of the
setting area varies according to the card type in use.
13