Changing Printer Settings
(Cont’d)
Setting Procedures
Make sure that you take down the set values before making any changes.
Print Settings
Resin K Ink Print Level: For setting the print density level of the Resin K ink.
UV Ink Print Level:
For setting the print density level of the UV ink. (Optional)
Special Ink 2 Print Level: For setting the print density level of the Special Ink 2. (Optional)
Resin K Ink Print Mode: For setting the print quality using the Resin K ink. Selecting “Fine” enhances
the printing quality, but slows down the printing speed.
MG Print (JIS): For specifying the way to peel the retransfer film of cards that come with a JIS
magnetic stripe when the JIS MG unit is mounted. The default setting is “Disable”.
Standby Mode: For specifying the card standby position while waiting for the laminator to switch to the
Ready mode during double-sided printing when the laminator is connected. The
default setting is “Front Wait”.
Cooling Time: For specifying the standby time in units of seconds before peeling the retransfer film
from the card after retransfer is complete. The default value is 0.
MG Unit
Number of Retry: For specifying the maximum number of retries when writing/reading of the magnetic
stripe fails. The default value is 1.
ISO Mode:
For specifying the coercivity with respect to the ISO magnetic stripe. The default
setting is “Hi-Co”.
Encoder Unit
Contact IC Encoder: For specifying the contact position of the contact IC encoder. The default setting
is “None”.
Non-contact IC Encoder: For specifying the antenna position of the non-contact IC encoder. The
default setting is “None”.
Others
Buzzer:
For enabling/disabling the alert sound when error occurs or when the card quantity is
running low, as well as the sound upon pressing the Enter key in the user mode. The
buzzer does not sound if you disable this feature. The default setting is “Enable”.
Power Saving Interval: Enables switching to the Power Save mode to reduce power consumption when
printing or operation is not performed over a specified time interval. Select whether to
disable the Power Save mode or the time interval before switching to the Power Save
mode. Selecting “Disable” deactivates the Power Save mode. The default setting is
“Disable”.
HR Control:
Switches to the standby mode by lowering the temperature of the retransfer heat roller
when printing is not performed for 30 minutes or longer. The default setting is
“Enable”.
.
11