Ordercode: 42273
Controller Pixelstrip MKII
Multiple Controllers (ArtNet/KlingNet Control)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Use a CAT-5/CAT-6 cable to connect the Controller, the PixelStrips and other KlingNet devices.
04)
Link the units as shown in fig. 05. Connect the first Controller's RJ45 "out" socket with the second unit's
"in" socket, using a CAT-5/CAT-6 signal cable. Repeat this process to link the second, third, and
fourth units.
05)
Connect the first PixelStrip’s RJ45 "out" socket with the second PixelStrip’s RJ45 "in" socket. Repeat this
process to link the second, third and fourth PixelStrip on each Controller.
06)
Supply electric power: Plug electric mains power cords into each unit's Blue/White socket, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Controllers ArtNet/KlingNet Set Up
Fig. 05
Note : Link all cables before connecting electric power
10
Summary of Contents for Controller Pixelstrip MKII
