HX33-DS Rev. A
Page 15 / 23
8
Normal Operation / Production Cycle
DANGER
+
Due to the risk of hand or finger injury, never try to reach into the machine before having
assured that the machine is disconnected from the air supply. Disconnect the air supply
before changing the safety guard and the dies.
CAUTION
+
The HX33 pneumatic crimp machine may only be set up and operated in perfect technical
condition, observing all the safety regulations and considering any possible dangers.
+
The crimp machine is only allowed to be used with mounted dies and safety guard.
+
When working with the HX33 pneumatic crimp machine, do not wear loose clothing,
jewellery or long, loose hair that can get caught in the HX33 pneumatic crimp machine.
+
Work with caution.
+
In cases of a machine malfunction, production must be stopped and the malfunction must
be fixed before continuing work with the machine.
+
Only one person is allowed to work on or with the machine at a time.
+
Only trained personal are allowed to work on or with the machine.
+
Assure free access to the operating elements of the machine, especially the foot pedal.
+
It is only allowed to work with the specified air pressure.
ATTENTION
+
Position the HX33 pneumatic crimp machine on a flat surface and assure the stability of the
machine. Ensure that the table or bench is stable enough to support the machine in normal
use. During the utilization, the machine has to be placed on a table or a similar flat surface.
+
Place the foot pedal on the floor. No other place is allowed. The foot pedal must be
movable, so that the operator has the possibility to change his position for ergonomic and
production needs. Do not lay the foot pedal in aisles or walkways.
+
Place the pneumatic tubes on the floor so that they do not cause a trip hazard.
Crimp process:
1. Insert the crimp contact in the die profile. Please pay attention to the correct profile
assignment and to the correct positioning within the crimp profile!
2. Insert the wire/cable which is stripped acc. to the specification and position it for crimping.
3. Press the foot pedal to start the crimp process.
4. Keep the foot pedal pressed until the crimp cycle is finished.
5. Remove crimped contact.
