DMC Combine CALC-U-DRI II, Owner'S Manual

Page: 7 / 24

9. Feed the power supply wires through the same grommet and route them to a
convenient power source in the cab.
Make sure that one end of the red wire is connected to the positive (+) side of a
power source and the other end to terminal number five. Likewise, one end of the
white wire should be connected to the ground (-) side of a power source and the
other end to terminal number four.
Pick up power from a source that is controlled by the ignition switch such as the
radio circuit. Use stick-on clips to route the power supply wires.
See Photo C.
CONTROL BOX INSTALLATION (continued)
Photo C
SENSOR INSTALLATION
1. The sensor should be mounted in the
clean grain auger tube in the combine
grain hopper. Use the template provided
to mark a 5-1/16” x 1-11/16” rectangle
on the bottom of the tube about 12 inches
from the end of the tube to the center of
the hole. The template may then be
discarded. Cut this rectangle out carefully
to make sure that the sensor block fits tight.
Do not torch cut! See Photo D.
Photo D
5
12V DC Power Black wire to Terminal 11
Red wire to Termial 5 Yellow wire to Terminal 12
White wire to Terminal 4 Red wire to Terminal 13
(For optional Combine Elevator Side Mount
See Pages 16-20)