DMC Combine CALC-U-DRI II, Owner'S Manual

Page: 6 / 24

4. For installations where the control box is to be mounted to a flexible surface, it may
be desireable to use a back-up plate or brackets to stiffen the mounting surface.
Use the cover of the control box as a template to mark the location of the six (6)
mounting holes on the back-up plate or brackets. Drill 0.140 diameter (9/64”) holes
in the back-up plate as pilot holes for the self-tapping screws that are provided for
mounting the box.
When the control box is mounted to a surface or panel that is held in place with
spring clips or other quick-latch devices, make sure that the control box will not
cause the panel to fall. It may be necessary to use additional mounting screws
for the panel or to attach a safety chain to insure that if the panel does become
loose it will not obstruct operation of the combine.
5. Select a location for the digital display such as the back side of the steering column.
Clean off the mounting surface with wood alcohol to remove any oil or dust before
sticking the display to the surface.
See Diagram 2.
Diagram 2
6. Use the stick-on clips to route the cable from the digital display to the Calc-U-Dri II
control box.
7. Feed the cable through the grommet on either side of the box and, leaving about
10 inches for connections. Cut off any excess cable.
8. Separate the individual wires in the cable. Remove one-quarter inch of insulation
on each wire and connect them to the terminal block posts as marked by the decal
(i.e., white to 18, green to 17, black to 16, brown to 15 and red to 14).
4
CONTROL BOX INSTALLATION (continued)