DKC INFORPRO1000, User Manual

Page: 128 / 148

126

At a start-up procedure, firstly turn on the UPS and then switch on the
load; at a shut-down procedure, firstly switch off the load and then
turn off the UPS.

Once the mains fails, the UPS switches to the battery mode. Please
save the data on a PC and shut down other loads before the battery is
discharged.

If the UPS is connected to the mains and is not used for more than 7
days, please refer to the section 5.4.2 to turn off the UPS.

If the UPS has not been used for more than 3 months, please refer to
the UPS start-up instructions with the mains, charge the UPS for at
least 8 hours to fully charge the battery and prolong its service life.
5.5 Display of UPS operating parameters

Press the query button or to check output, load, temperature,
input and battery information in turn.

In non-setting mode, press the button for 2 seconds to enter the
state of automatic page up/down, and re-press the button for 2
seconds to exit the state of automatic page up/down.

Output: The UPS screen displays the output voltage and output
frequency, as shown in the figure below:
Figure 15 – “Output” display

Load: The UPS screen displays the load power in Watts and Volt-
Amperes, as shown in the figure below: