Fog machine H-2VSD
3 / 19
1.1. Intended use of the device
This device is a device that was developed for professional use on stages, in
discotheques, theaters, etc. The device is only approved for connection to a
maximum of 230V, 50/60 Hz AC voltage and is only intended for indoor use.
Regular breaks in use increase the service life of your device.
Avoid physical shock or any form of violence when installing or starting up the
device.
Make sure that cables are not lying around freely. This would endanger your
own safety and the safety of third parties.
The device must not be operated or stored in an environment in which
splashing water, rain or moisture is to be expected. Moisture or high humidity
can reduce the insulation of the device and lead to fatal electric shocks.
When using fog machines, it must be ensured that the fog saturation of the
room must allow a good visibility of at least 10 m.
Do not operate the device during thunderstorms. Overvoltage could destroy
the device. In the event of a thunderstorm, completely disconnect the
device from the mains by pulling out the mains plug.
Surrounding objects or surfaces must not be touched by the housing.
Make sure that when assembling and dismantling the device, the area below
the assembly site is cordoned off. This also applies to the performance of
service work.
Familiarize yourself with the functions of the device before putting it into
operation. Do not allow the device to be operated by persons who have no
experience in it. The most common cause of malfunctions is improper
operation of the device.
Keep the device away from children and never operate it unsupervised.
Never aim the nozzle at people and keep 50cm away from the nozzle.
ATTENTION! The emitted mist is very hot.
Keep a minimum distance of 50cm to other objects.
Use only the recommended high quality water-based fluid from your dealer.
Other fluids can cause damage. Do not use flammable additives such as oil,
gas, perfumes, etc. in your fluid.
Never point the nozzle at an open flame or flammable objects.
Make sure to fill up the fluid in time. Running the machine without fluid can
damage the pump and heater block. Unplug the power cord when topping
up the fluid.
Never drink the fog fluid. If it did happen, contact a doctor immediately. If the
fluid comes into contact with the eyes and mucous membranes, rinse the
areas immediately with water.
Only operate the device in a horizontal position.
