3
in the donning mitt pocket.
6. Before tightening the brace, make sure the rear section is positioned evenly on
both sides of the patient.
7. To tighten the brace, slip your thumb through the hole in the pull tab. Pull away
from your body. When tightened, secure the pull tab to the loop exterior. Adjust
compression as needed.
(Figure D)
BRACE REMOVAL
8. Detach the pull tab from the loop exterior to loosen the brace. Unhook donning
mitt from the loop exterior and remove brace.
ADJUSTING PULL TAB LENGTH (OPTIONAL)
9. Remove lace spool from the pull tab pocket and wind lace around the spool to
shorten the length of the pull tab. Unwind lace from the spool to lengthen the
pull tab. (
Figure E
)
10. Insert lace spool back into pull tab pocket.
CLEANING INSTRUCTIONS:
Hand wash in water (
86
°F/
30
°C), using soap. Air dry.
NOTE:
If not rinsed thoroughly, residual soap may cause irritation and
deteriorate material.
Do NOT iron.
Do NOT tumble dry.
Do NOT bleach.
MATERIAL CONTENTS:
Nylon, Polyester, Polyurethane, Polyethylene, Cotton,
Acrylic, Polypropylene, Silicone, Synthetic Rubber, EVA.
WARRANTY:
DJO, LLC will repair or replace all or part of the unit and its accessories
for material or workmanship defects for a period of six months from the date of sale.
To the extent the terms of this warranty are inconsistent with local regulations, the
provisions of such local regulations will apply.
INTENDED FOR SINGLE PATIENT USE.
LATEX
NOT MADE WITH NATURAL RUBBER LATEX.
NOTICE: WHILE EVERY EFFORT HAS BEEN MADE IN STATE-OF-THE-ART TECHNIQUES
TO OBTAIN THE MAXIMUM COMPATIBILITY OF FUNCTION, STRENGTH, DURABILITY
AND COMFORT, THERE IS NO GUARANTEE THAT INJURY WILL BE PREVENTED
THROUGH THE USE OF THIS PRODUCT.
