63
Eng
lis
h
Note!
– If a pause has been programmed, the
carriage will stop for the pause each
time the maximum stretching value is
attained.
– Enabling the "stretching in plantar
flexion” function automatically disables
motor B. The only movement perform -
ed is dorsal extension/plantar flexion.
– It is not possible to combine a second
stretching function with the special
"stretching in plantar flexion” function.
– During operation, the display will
show the symbol
in the upper,
left-hand corner.
n
Stretching in inversion
With the special "stretching in inversion"
function the carriage gently stretches the
joint towards the inside.
Starting at the middle position the car-
riage will first move to the programmed
eversion value and then to the pro-
grammed inversion value.
Subsequently the carriage reverses 5°
towards eversion and then moves very
slowly back again to the programmed
inversion value (display:
for the right
foot and
for the left foot). After that
it attempts to attain another 5°, moving
even slower than before (display:
for
the right foot and
for the left foot).
If a high resistance toward the additional
5° is sensed, the reverse on load function
is automatically activated and the car-
riage moves in the opposite direction.
This stretch cycle is repeated ten times.
After that the carriage moves to the pro-
grammed maximum eversion value and
restarts the cycle “stretching in inversion”.
Default setting: disabled
Note!
– If a pause has been programmed, the
carriage will stop for the pause each
time the maximum stretching value is
attained.
– Enabling the “stretching in inversion”
function automatically disables mo-
tor A. The only movement performed
is inversion / eversion.
– It is not possible to combine a second
stretching function with the special
“stretching in inversion” function.
– During operation, the display will
show the symbol
in the upper,
left-hand corner.
n
Stretching in eversion
With the special "stretching in eversion"
function the carriage gently stretches the
joint towards the outside.
Starting at the middle position the car-
riage will first move to the programmed
inversion value and then to the pro-
grammed eversion value.
Subsequently the carriage reverses 5°
towards inversion and then moves very
slowly back again to the programmed
eversion value (display
for the right
foot and
for the left foot). After that
it attempts to attain another 5°, moving
even slower than before (display
for
the right foot and
for the left foot).
If a high resistance toward the additional
5° is sensed, the reverse on load function
is automatically activated and the car-
riage moves in the opposite direction.
This stretch cycle is repeated ten times.
After that the carriage moves to the pro-
grammed maximum inversion value and
restarts the cycle “stretching in eversion”.
Default setting: disabled
Note!
– If a pause has been programmed, the
carriage will stop for the pause each
time the maximum stretching value is
attained.
– Enabling the “stretching in eversion”
function automatically disables motor
A. The only movement performed is
inversion / eversion.
– It is not possible to combine a second
stretching function with the special
"stretching in eversion” function.
– During operation, the display will show
the symbol
in the upper, left-
hand corner.
Reminder:
You save the selected parameter values by
pressing the
STOP
button.
Summary of Contents for 80.00.035
Page 234: ...230 Notes ...
Page 237: ...VII Notes ...
