12
EN
Cleaning the Spark Arrestor
1. Use a screwdriver to remove the bolts and the
protective cover. Take out the spark arrestor.
2. Inspect the spark arrestor. Wash it with a cleaning
agent for carburetor and descale it with a wire
brush. Replace the spark arrestor if it is damaged.
3. Install the cleaned or new spark arrestor and
tighten the bolts.
Checking, Cleaning, and Replacing the Spark Plug
Contact a DJI-authorized dealer or DJI Support to maintain the spark plug.
1. Stop the generator and make sure it has cooled down completely.
2. Unscrew the spark plug with the dedicated spark plug socket and check
the spark plug. Replace the spark plug immediately if the insulator or the
sealing gasket is broken.
3. Remove the carbon deposit or other deposit with a stiff wire brush.
4. Adjust the electrode to make sure the gap is within a standard range of 0.6
to 0.8 mm.
5. When installing the spark plug again, thread the spark plug into the
engine by hand for two to three rotations.
6. Continue tightening with the dedicated spark plug socket.
• The recommended torque is 20-24 N·m. A loose spark plug causes the engine to overheat, while tightening the spark
plug too much will cause damage to the threads in the engine.
• The original spark plug model is F7RTC. Installing the wrong type of spark plug will damage the engine.
• To ensure proper operation of the engine, make sure the spark plug gap is correct and there is no deposit.
Specifications
Model
D12000iE
Starting Method
Start the generator via the engine switch
Operating Temperature
-5° to 40° C (23° to 104° F)
Max Operating Altitude
1000 m (The output power will drop if the generator is working at an altitude higher
than 1000 m.)
Rated Rotation Speed of Engine
3600 RPM
Fuel Type
Refer to the Appendix section.
Engine Oil Type
SJ 10W-40
Fuel Tank Capacity
30 L
Engine Oil Capacity
1.1 L
Rated Output
DC: 59.92 V
AC: Refer to the Appendix section.
Rated AC Power
Refer to the Appendix section.
Total Rated Power
9000 W
Maximum Engine Power
12000 W
Compatible Batteries
T40/T30/T20P Intelligent Flight Battery
Dimensions
765×740×705 mm
