DITECH DT5640, Instruction Manual

Page: 33 / 44

DEU
ENG
33
DEU
Commissioning
ENG
1. Select the desired channel at the Base station (see Base station instructions).
2. Press the System key of the Base station for 4 seconds, until the LED of the System key
3. flashes rapidly in orange.
9 The device LED starts to flash in orange.
4. Take off the room control unit Analog from the installation bottom (see fig. 5 page 5).
5. Pull out the insulating strip from the battery compartment, or insert batteries (see
fig. 6 page 5). If batteries have already been inserted, press the system key (C)
for at least 4 seconds in order to activate the teach-in mode.
9 The teach-in mode is activated automatically for 3 minutes.
9 The device LED flashes in orange.
The LED will light up in green after a successful teach-in process. If the
LED lights up red, repeat the process.
5.1.2 Teach-in to DITECH Smart Home iL central unit
For a control via the DITECH Smart Home iL app, the teach-in must of the DT5640
must be performed via the DITECH Smart Home iL central unit (DT5637). Teach-in
the device as follows:
Ö The DITECH Smart Home iL central unit has been set up via the DITECH Smart
Home iL app (see instructions DT5637).
1. Open the DITECH Smart Home iL app on the smart phone.
2. Select the menu item Teach-in device.