DITECH DT5640, Instruction Manual

Page: 37 / 44

DEU
ENG
37
DEU
Operation
ENG
6 Operation
The target temperature is set manually on a scale from 0 to 5 by turning the setting
wheel (E) to the left or to the right.
6.1 Set value balance (offset)
Since the temperature is measured at the room control unit, it may be warmer or
cooler in another position in the room. The deviation can be corrected via a set
value balance of -2 K to 2 K in 0.5 K increments.
1. Remove setting wheel (E). There is a scale for the balance on the inside of the
setting wheel (E) (see fig. 7 page 5).
2. Insert the set point correction limiter (F) to the desired place in the setting wheel (E).
6.2 Temperature limitation
The temperature range for the target temperature to be set as a maximum and
a minimum can be limited via the set value elements on the inside of the setting
wheel (E) (see fig. 8 page 5).
1. Remove setting wheel (E). Read the scale for the limitation on the inside of the
setting wheel (E).
2. Insert the target value elements (G) into the setting wheel (E) indicating the desired range.