DITECH DT5640, Instruction Manual

Page: 35 / 44

DEU
ENG
35
DEU
Commissioning
ENG
2. If necessary, release the device from the installation bottom with a suitable screw-
driver (see fig. 5 page 5).
3. Hold the installation bottom to the installation position. Take care to align the
installation bottom correctly (see fig. 4a page 4).
4. Align the installation bottom horizontally.
5. Mark two diagonally opposite bore holes using the installation bottom.
If wood walls are present, the screws can be screwed directly into the
wood. Pre-drilling with a 1.5 mm wood drill can facilitate the installation
of the screws.
6. For stone walls, drill the holes at the marked positions with a 5 mm masonry drill.
7. Insert dowels into the bores.
8. Install the installation bottom using the supplied screws (see fig. 4a page 4).
9. Position the room control unit Analog onto the installation bottom and latch it
in (see fig. 5 page 5).
5.2.2 Installation in flush-type box
The fixing holes on the installation bottom can be used for installation on a flush-
type box (see fig. 4b page 4).
1. If necessary, release the device from the installation bottom with a suitable screw-
driver (see fig. 5 page 5).