DITEC 0DT869, Installation Manual, Maintenance, Use

Page: 44 / 48

- 44 -
0DT869 2019-01-30
9. MAINTENANCE TO BE CARRIED OUT EVERY 6 MONTHS
Regular inspections should be made according to national regulations and product documentation by a Entrematic
Group AB trained and qualified technician. The number of service occasions should be in accordance with national
requirements and with the product documentation.
Safety Devices
• Check the correct operation of the safety device Linear Encoder (SLE)
• Check the correct operation of the safety photocells
Side guides
• Check the guides wearing and the relevant curtain sliding
Installation / Fitting
• Tighten the fitting screws of the uprights with the crosspiece
• Check the anchoring of the door to the door frame
Motor
• Check the fixing of the motor to the relevant support
• Check if encoder is working and its battery level
• Check the brake disc wearing. If necessary replace the disc
• Check motor silent block operation and integrity
Main Shaft
• Check the good bearing supports fixing
• Lubricate the support of the bearings by suitable grease inlet
Zipper status
• Check wearing and cleaning of the zipper
9.1 Maintenance Plan
The table below shows the recommended interval - in months - when to replace parts during preventive maintenance.
Part Part number
Cycles / hour operation
Abusive
Environment
(1)
<10
Low Traffic
<30
Medium Traffic
>30
High Traffic
Months Months Months
Brake disc 622337 36 24 12 12
Upper polizene guide
29448ARR
29448ARL
29448B
48 36 24 24
Lower polizene guide BGBST 48 36 24 24
Guide compensation spring KSPRING 36 24 12 12
Lens group and spacer for SLE 6GLSLEC 36 24 12 12
Motor silent block 5AV402510 48 36 24 24
(1) Dirty or dusty environment, operating temperature near to 0°C or over 35°C, wind pressure within 20% of maximum limit.
Date Cycle counter Signature Date Cycle counter Signature