12 / 16
Connecting the Wireless Receiver
The Wireless Receiver is connected to the controller using a 2m (6.5ft) telephone cable with 4P4C modular connectors at both ends. Do not exceed this
cable length. The Wireless Receiver’s telephone socket is located inside the device. To locate it, open the Wireless Receiver by separating its front and
back plates.
Figure 14: Location of the Wireless Receiver’s telephone socket
Connecting to the Controller’s Wireless Port
Each controller has a wireless port in which one end of the Wireless Receiver’s telephone cable plugs in.
Strain relief and Terminal Block Cover
In certain jurisdictions, terminal block covers are required to meet local safety regulations. Strain reliefs and terminal block covers are available for con-
trollers housed in large enclosures and are used to relieve tension on the wiring and conceal the controllers’ wire terminals. Strain reliefs and terminal
block covers are optional and are sold as peripherals.
Prior to connecting all wires, it is recommended to install the strain relief. Three screws are provided for its installation under the bottom part of the enclo-
sure. Tie wraps can then be used to group wires together and attach them securely to the strain relief in an effort to relieve undue tension. If necessary,
the terminal block cover can then be clipped on to the strain relief as shown below.
Figure 15: Large enclosure strain relief and terminal block cover installation
Maintenance
Unplug device before any kind of servicing.
The device requires minimal maintenance, but it is important to take note of the following:
£
If it is necessary to clean the outside of the device, use a dry cloth.
£
Using a torque limited screw driver set to 0.4 Nm (3.54 in-lb), retighten terminal connector screws annually to ensure the wires remain securely
attached.
