User manual in Original
Doc. ref: 500A_MB_am_en_210602
DISPERATOR AB
Tel: 08-724 0160
E-mail: [email protected]
Mälarvägen 9, 141 71 Segeltorp
Web page: www.disperator.se
35 / 41
34 / 41
10. Pry the stationary shredder (P13) loose from the end shield (P3) using a crowbar that levers
against the large tooth on the inside edge and is supported by the rotary shredder (P10) close to
one of the two shredder blades. See photo below.
11. Loosen the axle screw (P12). If the rotating shredder (P10) keeps turning, and cannot be held
still manually, use a pipe wrench to hold one of its shredder blades. Alternatively, lock the rotary
shredder with a screwdriver placed through one of the holes at the disposer outlet (see photo
below).
12. Remove the rotary shredder (P10) by placing two crowbars opposite one another under the edge
of the shredder, supported by the side of the end shield (P3). See photo below.
13. Remove the V-ring seal (P8) and loosen the 4 fixing screws (P7) of the end shield (P3).
Note the
position of the outlet on the end shield (P3) relative to the terminal box for cable connection
on the motor (P1), so that this outlet will receive the same direction when reassembling the
disposer.
Remove the end shield.
14. Inspect the washer (P4) for possible wear caused by the V-ring seal. Replace the washer if
necessary.
15. Turn the end shield (P3) upside down and remove the locking ring (P6)
by means of a circlip
pliers.
See photo below. With some adequate protection in between (e.g. a piece of wood as in
the below photo), apply pressure to the washer (P4) in order to get the two axle seals (P5) out.
After this dismantling make sure that the surface of the sealing washer (P4) remains in good
condition.
Summary of Contents for EXCELLENT 500A-MB Series
Page 2: ......
