User manual in Original
Doc. ref: 500A_MB_am_en_210602
DISPERATOR AB
Tel: 08-724 0160
E-mail: [email protected]
Mälarvägen 9, 141 71 Segeltorp
We page: www.disperator.se
34 / 41
9.3. Overhaul of Protection Cover with Switch, Assembly and Connections
The below designations within brackets refers to the position numbers on the exploded view drawing
with associated spare part list of the disposer in section 9.2.
The following checks of the machine must be done in accordance with the table in section 9.6,
“Overhaul and Maintenance Intervals” – i.e. make sure that:
•
all screws and nuts (P18) between disposer and assembly are tightened and in good condition,
•
disposer connection to the sewer pipe is sealed and fixed,
•
the flushing water connection for disposer is sealed and fixed,
•
all cable glands are tight and fixed,
•
the disposer is securely fixated either to the wall/bulkhead or the floor/floor plate.
9.4. Dismantling of Disposer
The below designations within brackets refers to the position numbers on the exploded view
drawing with associated spare part list of the disposer in section 9.2.
1. Use the main electrical security breaker on the wall/bulkhead to disconnect electrical supply and
lock the breaker with a padlock.
2. Disconnect the flushing water supply to the disposer by closing a valve in the supply line.
3. Disconnect the disposer motor (P1) connection cable from the start & stop control unit.
4. Disconnect the water trap from the disposer outlet on the end shield (P3).
5. Use a trolley which lifting plate can be inserted under the disposer, or alternatively a steady jack
with lifting plate. Detach the disposer from the assembly (6 screws and nuts, P18), and remove
possible disposer fixation from the wall/bulkhead or floor/floor plate. Move the disposer to a
suitable workbench for the continued dismantling.
For disposers installed in closed cabinets (e.g. the models in 500-MB and 500-MC series) the
parts with position number (P19) up to and including (P25) are not used. For these start the
dismantling of the disposer from item 8 below by loosening the four nuts with washers (P16).
6. Turn the grinder upside down and remove the housing (P20) by loosening the two screws (P23),
and loosen the cable gland (P22) and insert the cable into the housing.
7. Mark on the end shield (P3) the position of the strap (P19) and then remove it by loosening two
nuts (P16). Turn the grinder over again. Loosen the remaining two nuts with washers (P16).
8. These four nuts (P16) must always be changed for new ones before reassembly, as they are
lock nuts. Note the location of the disposer outlet on the end shield (P3) relative to the hole
pattern on the hood (P15) upper side, so that the outlet later may be reassembled in the same
direction. For this purpose, is also an arrow engraved on the hood (P15) lower edge, which when
reassembling shall be above the outlet of the end shield (P3). Remove the hood (P15).
9. Remove the seal (P14) on the stationary shredder. This seal must always be replaced with a new
seal when reassembled.
Summary of Contents for EXCELLENT 500A-MB Series
Page 2: ......
